28 Gauge Dampers

Available with or without handles

3-Blade Crimper - Sheet Metal

Downsizes heavy stove pipe and round metal duct to create a male connection for joining sections.

5-Blade Crimper - Sheet Metal Pipe

The five blades on the Malco C5R allows maximum crimping power, producing a 1-5/8 inch (41.3 mm) long, shallow, double crimp that replicates factory indentations and ensures a tight fitting, leak-proof connection.

5-Blade Crimper - Sheet Metal Pipe, Offset

Works overhead to downsize round metal duct and create a male connection for joining sections.

Damper Regulator Hardware

For use on 24-30 gauge galvanized steel.

Duct Holder

For holding ductwork in place. Duct Holders: 1-Pair of clamps with chain.

Duct Ripper

Specially angled ground tip easily punctures and rips duct to the desired length starting hole.

Duct Stretchers

Use the Duct Stretcher to hold duct in place with one hand while slipping drive cleat in place with other hand.

Hand Notcher - 1 Inch

For metal duct corner notches. Makes a clean 1-inch deep “V” shaped cut in 24-gauge (0.71 mm) galvanized or (0.61 mm) mild steel.

Hand Notcher 13/16 Inch

For metal duct corner notches and take-off tabs. Makes a clean 30° “V” shaped cut in 24-gauge (0.71 mm) galvanized steel.

Locking Duct Stretcher

Locking duct stretcher pulls duct sections together and holds them in place while freeing both hands to align and install drive cleats.

Power Assisted TurboCrimper C

Use your existing drill to save time and effort crimping.

Single Crimper

Fast, easy to use and lightweight. Handy lock makes tool pocket sized.

Snap Lock Punch - Sheet Metal

Raises a projection along edge of metal sheet for locking into rolled edge of sheet to be joined.

TurboCrimper IMPACT

Quickly makes your impact driver a power crimper for 30-24 ga. (0.41-0.71 mm) round metal duct and (0.31-0.61 mm) stove pipe. The extra sheet metal crimping power of the TurboCrimper, is five times faster than a manual crimp, making your job a lot easier.