Home / Redline Handle Tools
Trademark
Product Categories
Markets
5-Blade Sheet Metal Crimper
The five blades on the Malco C5R allows maximum crimping power, producing a 1-5/8 inch (41.3 mm) long, shallow, double crimp that replicates factory indentations and ensures a tight fitting, leak-proof connection.
5-Blade Offset Sheet Metal Crimper
The offset sheet metal crimper is an ergonomic solution that is ideal for tight working quarters or working over-head.
3-Blade Sheet Metal Crimper
Downsizes heavy stove pipe and round metal duct to create a male connection for joining sections.
J-Channel Cutters
Makes drain tabs, downstream notch cutouts and miter trim cuts for vinyl siding J-Channel.
Nail Hole Punch, Vinyl
Makes a horizontal slot for adding or elongating nail holes in vinyl or aluminum siding to accommodate stud spacing.
Snap Lock Punch for Vinyl Siding
The Vinyl Siding Snap Lock Punch Produces wider, more prominent rectangular tab projections for securing vinyl skirting or siding to finishing trim.
Ceiling Grid Punch
Accesses tight corners to make 1/8 inch (3.2 mm) rivet holes in up to three layers of 25 gauge (0.53 mm) tees and angles.
Punch Lock, Metal Stud Crimper
Secures metal stud and runner without fasteners. Squeeze handles together with one hand while holding stud in place.
Gutter End Cap Crimper (Adjustable Snap Lock Punch)
Ideal gutter tool to use for crimping end caps in place. Also creates locking tabs in light sheet metals.
5-Blade Gutter Downspout Crimper
Produces an effective double crimp that downsizes corners of aluminum or steel downspout. Crimps made by the tool help create a connection that is more self-supporting during gutter installation.
Fiber Cement Siding Snip
For precise arc and trim cuts in 5/16 inch (7.9 mm) fiber cement siding plank fast and easy.
Vinyl Fence Hand Notcher – 1/2″ and 3/4″
Creates 1/2 and 3/4 inch (19.1 mm) wide, 7/8 inch (22.2 mm) deep louver-shaped tabs to lock vinyl pickets and rails in place.
Hand Seamers with Forged Jaws
For bending metal and flattening seams, as well as straightening sheet metal or safely gripping and moving metal on the job.
Hand Seamers with Cast Zinc Jaws
For bending, seaming and straightening non-ferrous metals and limited flattening/straightening applications in light gauge steel.
PEX To Wire Tool
Labor-saving way to layout an in-floor radiant heating system on a wire grid.
Hand Notcher – 13/16 Inch and 1 Inch
Model N1R for metal duct corner notches and take-off tabs makes a clean 30° “V” shaped cut in 24-gauge (0.71 mm) galvanized steel. Model N2R for metal duct corner notches makes a clean 1-inch deep “V” shaped cut in 24-gauge (0.71 mm) galvanized or (0.61 mm) mild steel.
Hole Punch – Sheet Metal, Vinyl Plastic
Use for edge hole applications in sheet metal or vinyl plastic including metal ductwork and vinyl window extrusions.
Snap Lock Punch for Sheet Metal
Raises a projection along edge of sheet metal for locking into rolled edge of sheet to be joined.
